SKC-S is an NDT-approved solvent cleaner/remover for pre-cleaning before non-destructive testing and for removing excess surface penetrant from an inspection area before applying developer during liquid penetrant testing. This non-halogenated solvent remover can be used on a wide range of substrates to remove oils, greases and other contaminants. SKC-S dries quickly without leaving a residue, and meets the low-residue requirements for NDT and aerospace penetrant testing.
Features
SKC-S is an NDT-approved solvent cleaner/remover for pre-cleaning before non-destructive testing and for removing excess surface penetrant from an inspection area before applying developer during liquid penetrant testing
Contains gas under pressure - may explode if heated. May be fatal if swallowed and enters airways.
Causes skin irritation.
May cause drowsiness or dizziness.
Keep away from heat, sparks, open flames and hot surfaces. No smoking.
Do not spray on an open flame or other ignition source.
Pressurized container: Do not pierce or burn, even after use.
Avoid breathing dust, fumes, gas, mist, vapours and spray.
Wash hands, forearms and face thoroughly after handling.
Use only outdoors or in a well-ventilated area.
Wear protective gloves, eye protection and face protection.
If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting.
If on skin: Wash with plenty of water. Take off contaminated clothing and wash it before reuse.
If skin irritation occurs: Get medical advice/attention.
If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell.
Store in a well-ventilated place
Store locked up
Protect from sunlight.
Do not expose to temperatures exceeding 50°C/122°F.
Dispose of contents and container to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulations
